Hi,
In article <[EMAIL PROTECTED]>,
Jon Geraghty<[EMAIL PROTECTED]> wrote:
> It connected up to my slimserver fine but then recommended a firmware
> update. So I dutifully held down <brightness> on the remote and set it
> updating. It then gave some message like "restarting, this may take a
> minute" and the display went blank never to return to life. I waited 10
> minutes and tried removing/reinserting the power lead but to no avail. I
> also tried holding down <power> for many seconds, and even holding <add>
> upon reinserting the power lead to do a factory reset.
I had something similar happen to me one time after a firmware update. Try
pressing the 'Brightness' button on the remote a few times. I think somehow
it had got set to minimum brightness (i.e. display off) during the update.
Andy
_______________________________________________
discuss mailing list
[email protected]
http://lists.slimdevices.com/lists/listinfo/discuss
