FB67;281456 Wrote: > Running SqueezeCenter on ReadyNAS NV+. One SB3, one Controller. Last > night everything worked fine, tested it for a few minutes and went to > bed. > > Came home from office today, the Controller apparently ran out of > power. I didnt realize that it was possible to switch it off. > > It has been charging for a couple of hours now, then I powered the > Controller up again, but it never gets further than the Logitech logo > screen. > > I have tried to restore the Controller settings by powering off, > holding the Add key pressed while powering up again. Nothing happens, > the Controller stops at the logo screen. > > Any ideas? > > Best regards > FB67
The Squeezebox Controller has 2 copies of the firmware -- current and previous. It was designed like that for situations like yours! Given your symptoms, it's possible that your current image somehow is not right. Try switching to your previous copy of firmware by holding down the "volume up" key while turning on (press the key with the picture of the house) the Controller. If it successfully starts up, you'll need to wipe out the bad "current" image by performing a software update (Settings->Advanced->Software Update). Once that finishes, turn off the Controller and then turn it back on. You should then be OK. If this doesn't work, you need to contact support. http://forums.slimdevices.com/showthread.php?t=40033 Mickey -- MickeyG Transporter > Classé Audio DR6 > Mark Levinson 23 > Wilson Watt 3/Puppy 1 ------------------------------------------------------------------------ MickeyG's Profile: http://forums.slimdevices.com/member.php?userid=11644 View this thread: http://forums.slimdevices.com/showthread.php?t=45010
_______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
