Robin Bowes wrote: > mflint wrote: > >> (For some reason, Net-UDAP couldn't discover the SBR unless it was >> hard-wired to my router) >> > > I wrote the tool specifically to configure a factory-supplied (i.e. no > config) SBR from a PC without requiring a SBC. Until the SBR is > configured, it cannot connect to any wireless network (the SBC sets up > an AdHoc wireless network to connect wirelessly to the SBR) so you won't > be able to connect to it wirelessly from a PC. > > Even when configured, the UDAP protocol is UDP-based so the UDAP source > (PC) and UDAP destination (SBR) have to be on the same network segment. > There's no causality in that. UDP works fine over the Internet. You probably mean it's broadcast based which does pretty much limit it to a network segment.
> It is possible that it might work across a wireless network, i.e. PC + > SBR connected to the same wireless network, but I've not tested that and > don't intend to. > > When I get round to releasing it officially, I will write some > instructions which will begin something like: > > Plug SBR into same switch/router as PC > (rest of instructions) > Great work! Regards, Peter _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
