Hi all. I currently have a SB3 and SB1 (with upgraded display)and have had the SB1 since 04, so I'm no newb to getting these guys to work on my wireless network.
I just purchased a 3rd unit, a used SB3 on ebay. I know what I have to do to add things to my wireless network, so I go ahead and add the MAC address to my router's MAC filter list, plug in the SB3 and configure it to use my wireless nw, also inputting my 128b WEP key... it gets through the part where it actually connects to my wireless network but fails upon finding a DHCP server... I checked my DHCP server and all is fine. I plugged the SB1 that's replacing back in, also running from DHCP, and it grabbed an address just fine. I even tried setting a static address of the new SB3, but then it just hangs there when trying to contact my SC server. It seems like it cannot communicate over the wireless at all. So, I plug it in with an ehternet connection to see what happens, and it grabs an IP just fine, then downloads and installs Firmware ver. 88. It reboots and works fine, on the wire. So, I try it off of the wire again, on the wireless, and again, same behavior. I'm hightly skeptical that it's anything on my network here since I have several wireless devices, including two other SBs working just fine. Are there any known issues similiar to this one? Does the SB unit 'remember' it's old network for some reason and need to be flushed somehow? Any input or guidance is greatly appreciated. Thanks. -- marticus24 ------------------------------------------------------------------------ marticus24's Profile: http://forums.slimdevices.com/member.php?userid=2441 View this thread: http://forums.slimdevices.com/showthread.php?t=50766 _______________________________________________ discuss mailing list [email protected] http://lists.slimdevices.com/lists/listinfo/discuss
