Hello,
>I have installed openvswitch on VMware (linux system), and I followed the
>instruction to replace it for a linux kernel bridge.
>m...@ubuntu:~/openvswitch-0.99.2$ cat /etc/ovs-vswitchd.conf
>bridge.bri.port=bri
>bridge.bri.port=eth0
>m...@ubuntu:~/openvswitch-0.99.2
>
>
>However, after setting up the bridge and interface, the internet connection in
>VMware seems down because I can not open any website through firefox in
>VMware. I have no idea what the problem is.
>
>
>And last time I asked this question, you replied me as follow:
"You need to move your IP address from eth0 to bri. The switch will take the
packets from eth0 before they make it to the IP stack, which is why you have
the local port."
But I still don't know the exact steps how to switch the IP address, could ypou
give me a more specified instruction.
And more, in "ovs-vsctl" , could you tell me about the differences between
"bridge" and "fake bridge" and the differences between "port" and "interface",
and how to config them, Thank you!
Best regards,
Xin
_______________________________________________
discuss mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/discuss_openvswitch.org
