On Thu, May 20, 2010 at 12:01 PM, Axle Judd <[email protected]> wrote:
> Hi, > > I installed openvswitch version 1.0.0 on XenServer 5.6 , then i created a > NIC bonding using Physical interface eth2 and eth3 but when i looked bonding > mode it's showing up as "source load balancing". > > I tried to add mode=802.3ad in /etc/modprobe.conf file rebooted server but > mode is still showing up as "slb". > > Where can i change the mode to 802.3ad , ? > SLB is the only supported mode of bonding. 802.3ad is not implemented.
_______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss_openvswitch.org
