Hello,
After much hard work, troubleshooting, and experimenting, I was finally
able to get OpenFlow up and running! However, I am now trying to make
the steps concrete and I have a few questions.
I created my virtual bridge vbr0 using ovs-vsctl while ovs-vswitchd was
running. I now want to use ovs-openflowd instead. However, it seems I
cannot form a connection between ovs-controller and ovs-openflowd unless
I do an ifconfig on vbr0. This, however, requires ovs-vswitchd to be
running. How can I do this using only ovs-openflowd?
Also, I'm not exactly sure which IP address I should use for the
datapath, and which IP address I should use for running in-band
communication. I tried using ptcp: to connect the controller and
OpenFlow switch but this didn't work.
My set-up is as follows:
- Open vSwitch runs in a Virtual Machine.
- Other vm hosts connect to the switch vm via an internal network (one
for each host).
_______________________________________________
discuss mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/discuss_openvswitch.org
