I am using openvswitch-1.1.0pre2. Should I check out the latest revision from git instead?
Thanks, Akbar On Wed, Feb 23, 2011 at 10:40 PM, Ben Pfaff <[email protected]> wrote: > On Wed, Feb 23, 2011 at 09:43:11PM +0500, Syed Akbar Mehdi wrote: > > I am trying to use Open vSwitch without kernel support. I installed OVS > > following the instructions in > > > http://openvswitch.org/cgi-bin/gitweb.cgi?p=openvswitch;a=blob_plain;f=INSTALL.Linux;hb=HEAD > . > > However I did not create a bridge using ovs-vsctl as indicated at the end > of > > that manual. Instead I followed the instructions given in > > "INSTALL.userspace" and tried to start the ovs-openflowd in userspace > mode > > using the command: > > > > ovs-openflowd netdev@br0 --ports=eth0,eth1,eth2 > > > > The problem is that ovs-openflowd crashes with a segmentation fault. Here > is > > the output I get: > > What version of OVS are you using? We recently fixed a segmentation > fault in the userspace switch. > -- Regards, Syed Akbar Mehdi, School of EECS (SEECS), National University of Sciences and Technology (NUST), Pakistan.
_______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss_openvswitch.org
