Why don't you only run Open vSwitch and rmmod the bridge module? (And again, please respond on-list.)
--Justin On Jun 5, 2011, at 1:38 AM, manel med wrote: > ok,if brcompat_mod is loaded what should i do and how please, i can't kill > it! > > 2011/6/5 Justin Pettit <[email protected]> > [Once again, let's keep this on the mailing list.] > > Are you running OVS in bridge compatibility mode? (Specifically, is the > brcompat_mod kernel module loaded?) If it is, I imagine that things could > get very confused about which networking "bridge" should be receiving > commands. > > Generally, if you're running OVS, you shouldn't need to be running the bridge. > > --Justin > > > On Jun 5, 2011, at 1:05 AM, manel med wrote: > > > I patch the kernel to allow both to run at the same time, I use 2.6.36. > > > > lsmod | grep bridge > > bridge 70361 0 > > stp 1603 2 grap,bridge > > > > manel > > > > > > 2011/6/5 Justin Pettit <[email protected]> > > [Let's keep this on the list.] > > > > On Jun 4, 2011, at 4:31 PM, manel med wrote: > > > > > I know that it's appear in "brctl show"and in "ovs-vsctl list bridge" and > > > not in "ovs-vsctl list bridge" but i don't know why. > > > i run > > > insmod datapath/linux-2.6/openvswitch_mod.ko (how may time should i run > > > it?) > > > > You should run it only once. My question was whether the bridge module was > > installed, too: > > > > lsmod | grep bridge > > > > OVS will normally complain about this, but some later versions of the > > kernel allow both to run at the same time, and I'm not sure how OVS handles > > that situation. > > > > > i use openvswitch-1.1.0. > > > > I don't know that it will fix your particular problem, but 1.1.1 is out. > > Please try that. > > > > --Justin > > > > > > > > _______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
