This could be because I'm trying to use the same interface (eth0) for both
traffic and openflow control, but it is causing me a problem and I want to
know if theres any way to get around it.
I have open vswitch and virtualbox set up on a laptop with one physical
Ethernet port. That port is connected to a hardware switch with openflow
capabilities. This switch is connected to the Beacon controller. When I turn
on the controller, it registers the switch and the openvswitch machine.
However, the VM on the openvswitch machine can't talk through/to the
hardware switch. I figure this is because I haven't done "ovs-vsctl add-port
lan0 eth0" to put eth0 on lan0, which is the bridge where the VM is on.
However when I do that, it disconnects from Beacon. Is there any way around
this or do I need two physical ports?
Thanks.
---------
Ryan White
Research Engineer
Intelligent Automation, Inc.
15400 Calhoun Drive, Suite 400
Rockville, MD 20855
http://www.i-a-i.com
Email : [email protected]
Direct: (301) 294-5223
__________________________________________________________________________
This message and all attachments are PRIVATE, and contain information that
is PROPRIETARY to Intelligent Automation, Inc. You are not authorized to
transmit or otherwise disclose this message or any attachments to any
third party whatsoever without the express written consent of Intelligent
Automation, Inc. If you received this message in error or you are not
willing to view this message or any attachments on a confidential basis,
please immediately delete this email and any attachments and notify
Intelligent Automation, Inc.
_______________________________________________
discuss mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/discuss
