Thanks a lot, Ben [?]

On Fri, Jul 27, 2012 at 1:27 PM, Ben Pfaff <[email protected]> wrote:

> On Fri, Jul 27, 2012 at 11:00:35AM +0800, Kris zhang wrote:
> > Hi
> >
> > I have a question about RSPAN, so i only find the following descriptin in
> > vsctl manual page:
> >
> > *Port Mirroring*
> > *Mirror all packets received o r sent on eth0 or eth1 onto eth2, assuming
> > that all of those ports exist on*
> > *bridge br0 (as a side-effect this causes any packets received on eth2 to
> > be ignored):*
> > *ovs-vsctl -- set Bridge br0 mirrors=@m \*
> > *-- --id=@eth0 get Port eth0 \*
> > *-- --id=@eth1 get Port eth1 \*
> > *-- --id=@eth2 get Port eth2 \*
> > *-- --id=@m create Mirror name=mymirror select-dst-port=@eth0,@eth1
> > select-srcport=@eth0,@eth1 output-port=@eth2*
> >
> > there is no any vlan in above command, and in ovs-vswitchd.conf.db.5,
> there
> > is an *output_vlan* in mirror table, but i still confuse how to setup
> > RSPAN, so could u please give me a simple example?
>
> Q: How do I configure a VLAN as an RSPAN VLAN, that is, enable
>    mirroring of all traffic to that VLAN?
>
> A: The following commands configure br0 with eth0 as a trunk port and
>    tap0 as an access port for VLAN 10.  All traffic coming in or going
>    out on tap0, as well as traffic coming in or going out on eth0 in
>    VLAN 10, is also mirrored to VLAN 15 on eth0:
>
>        ovs-vsctl add-br br0
>        ovs-vsctl add-port br0 eth0
>        ovs-vsctl add-port br0 tap0 tag=10
>        ovs-vsctl \
>            -- --id=@m create mirror name=m0 select-vlan=10 output-vlan=15 \
>            -- set bridge br0 mirrors=@m
>
>    (If you omit select-vlan=10, then all traffic on any VLAN, except
>    VLAN 15, will be mirrored to VLAN 15.  This is possibly confusing
>    because the packets' original VLANs cannot be determined.)
>
>    To later disable mirroring, run:
>
>        ovs-vsctl clear bridge br0 mirrors
>
>    Mirroring to a VLAN can disrupt a network that contains unmanaged
>    switches.  See ovs-vswitchd.conf.db(5) for details.  Mirroring to a
>    GRE tunnel has fewer caveats than mirroring to a VLAN and should
>    generally be preferred.
>

<<330.gif>>

_______________________________________________
discuss mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/discuss

Reply via email to