I,
I test again with this config :
switch physique port 1-2 lacp L3-L4 tag 10, 20
port 3 tag 30
coté OVS bond0 eth0 eth1 lacp=active other-config:lacp-time=fast
bond_mode=balance-tcp trunk=10,20
when i'm add eth2 tag=30 on bridge PROD I lost my connection for few minutes.
I have enable ELRP on my switch (for prevent loop) the physical switch don't
see any loop.
so, it is a normal reaction ?
I don't see anything on log, but on flow I see when i'm add (or del) my eth2
tag=30 in bride PROD all flow disappear. at least when the connection came
back, i see correct flow with pop_vlan ..
In laps time where i lost connection, the flow on my bond is "actions:drop"
I'm sure i have not a loop in my physical switch, and if i have a loop in OVS
then i have different tag on my interfaces it's problematic ..
i hope i explain fine my problems ..
_______________________________________________
discuss mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/discuss
