Is the script local or remote? You need to run the command atomically from the remote perspective. This means you need the ssh command to be a single one, likely along the lines of:
ssh user@remote remote_script or ssh user@remote "command && command ; command" . A local script would not work unless it invoked all the commands on a single command line. Hope this helps. -Reid PS here's the FAQ note you're referencing: (If your only connection to the machine running OVS is through the IP address in question, then you would want to run all of these commands on a single command line, or put them into a script.) On Tue, Feb 19, 2013 at 2:15 PM, Jing Ai <[email protected]> wrote: > Hey, > > I've noticed that there is already a FAQ illustrating the steps to add eth0 > to the bridge, e.g., br0 as follows. > > ovs-vsctl add-br br0 > ovs-vsctl add-port br0 eth0 > ifconfig eth0 0.0.0.0 > ifconfig br0 <eth0's IP address> > > Since I issued the above commands on a remote host via ssh, I also put them > in a script as instructed. However, when I run such a script, I immediately > lost the connection to the remote host. Any idea? > > Best, > Jing > > > _______________________________________________ > discuss mailing list > [email protected] > http://openvswitch.org/mailman/listinfo/discuss > _______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
