On Wed, Apr 10, 2013 at 2:25 AM, Sayed Qaiser Ali Shah Shah <[email protected]> wrote: > Hello everybody, > > I am using mininet 2.0 OVS with POX controller. I want to use queues in OVS. > I want to limit port 1 of ovs switch what I did is as below > > xterm s1 > > then in xterm of s1 type the command > > ovs-vsctl – set Port s1-eth1 qos=@newqos – – id=@newqos create QoS > type=linux-htb other-config:max-rate=10000 queues=1=@q1 – --id=@q1 create > Queue other-config:min-rate=100 other-config:max-rate=10000 > > This command will set QOS parameters on eth1 of switch s1. It will also > attach queue (q1) with interface. This command sets maximum rate for each > queue as 10000 bps. This will result in lower bandwidth because the > bandwidth which is allocated here is less than bandwidth in the absence of > QoS. This can be test by using following commands. > But when I check the result I got same bandwidth as without QoS > implementation. > Can anybody help me out of this. How can I solve this issue?
Did you read the QoS entries in the FAQ? _______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
