I want to check that inactivity probe message is not sent by the switch to the controller after the unix socket is disconnected.
On Thu, May 16, 2013 at 11:47 AM, Ben Pfaff <[email protected]> wrote: > OK. But what is your higher level goal? The best way to observe the > inactivity probe message depends on how you plan to react to it. > On May 15, 2013 11:07 PM, "akash sharma" <[email protected]> > wrote: > >> Thanks for the response. >> It resolves my two queries. >> Regarding query#2, I need to capture the "inactivity-probe" message sent >> by the switch to the controller. >> But I am not able to understand how can I capture the messages/packets >> exchanged between the switch and the unix controller. >> >> Regards, >> Akash >> >> On Thu, May 16, 2013 at 11:26 AM, Ben Pfaff <[email protected]> wrote: >> >>> On Thu, May 16, 2013 at 11:23:23AM +0530, akash sharma wrote: >>> > 1. I need to disconnect the unix socket. >>> > >>> > I deleted the link created above using the following command: >>> > >>> > [root@user]rm /usr/local/var/run/openvswitch/br0.mgmt >>> > >>> > Am i correct or is there any other way to disconnect the unix socket >>> from >>> > bridge? >>> >>> ovs-vsctl del-controller br0 >>> >>> > 2. Also, I am not able to understand where to check for the >>> > "inactivity-prove" message sent by the switch to the unix controller. >>> >>> What do you mean by "to check for" it? >>> >>> > 3. Does setting inactivity-probe to zero triggers the switch to enter >>> in >>> > fail-open mode? >>> >>> No. >>> >> >>
_______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
