Did you read the documentation?
VLAN Splinters:
The ``VLAN splinters'' feature increases Open vSwitch
compatibility with buggy network drivers in old versions of Linux
that do not properly support VLANs when VLAN devices are not
used, at some cost in memory and performance.
[...]
It does not make sense to enable VLAN splinters on an interface
for an access port, or on an interface that is not a physical
port.
On Thu, Nov 07, 2013 at 01:12:41PM +0530, Linux user wrote:
> Hi Ben,
>
> Are you saying that VLAN splinters not apply on Virtual network interfaces
> ?
> Then how to make Vlan work on virtual network like ovsbr0.4093 ?
>
> Thanks
>
>
> On Thu, Nov 7, 2013 at 11:37 AM, Ben Pfaff <[email protected]> wrote:
>
> > Your first message specifies the wrong command, you have to apply the
> > splinter to the physical port but you applied it to ovsbr0.
> >
> > On Thu, Nov 07, 2013 at 11:30:00AM +0530, Linux user wrote:
> > > Hi Ben,
> > >
> > > Done like :
> > > other-config:enable-vlan-splinters=true
> > >
> > > But its not work out (please see my starting mail thread) .....
> > >
> > > Thanks
> > >
> > >
> > > On Thu, Nov 7, 2013 at 11:27 AM, Ben Pfaff <[email protected]> wrote:
> > >
> > > > On Thu, Nov 07, 2013 at 11:24:21AM +0530, Linux user wrote:
> > > > > Hi Ben,
> > > > >
> > > > > Thanks for this info, but I already know that ...
> > > > >
> > > > > My problem is that, Every time when system reboot then i use the
> > command
> > > > > like:
> > > > > vs-vsctl set interface eth0
> > other-config:enable-vlan-splinters=true
> > > > >
> > > > > I want to integrate this command into network scripts
> > > > > files(/etc/sysconfig/network-scripts/ifcfg-*)
> > > > >
> > > > > Just like, I have network configuration like below:
> > > > > [root@linux]# ovs-vsctl show
> > > > > f95289de-40e2-4bf5-9f07-
> > > > > 3c8300e296db
> > > > > Bridge "ovsbr0"
> > > > > Port "eth0"
> > > > > Interface "eth0"
> > > > > Port "ovsbr0"
> > > > > Interface "ovsbr0"
> > > > > type: internal
> > > > > Port "ovsbr0.4093"
> > > > > tag: 4093
> > > > > Interface "ovsbr0.4093"
> > > > > type: internal
> > > > > ovs_version: "1.4.6"
> > > > >
> > > > > [root@linux]# lsmod | grep openvswitch
> > > > > openvswitch 37890 1
> > > > >
> > > > >
> > > > > So how to integrate VLAN splinters command into network scripts file
> > > > here ?
> > > >
> > > > Why not just add that ovs-vsctl command to your network scripts file?
> > > >
> >
_______________________________________________
discuss mailing list
[email protected]
http://openvswitch.org/mailman/listinfo/discuss
