Hi, Thanks for the reply. I have some more doubts. Pleae clarify 1. Is bond_detect_mode defaulted to carrier in Openvswitch.(am using openvswitch 2.1.0) 2. When this is set to carrier if a switch has two entries for the same destination(with different priorities) in its flow table and the link corresponding to higher priority flow table entry fails, how the switch will behave. -will it use the second entry automatically.(without controller's intervention) -what will happen to the higher priority entry..will it be kept there - Will it send a message to the controller abt the link failure.
Thanks & regards, Padma V On Fri, Oct 17, 2014 at 3:21 AM, Ben Pfaff <[email protected]> wrote: > On Thu, Oct 16, 2014 at 10:25:27PM +0530, Padma Jayasankar wrote: > > How an op,envswitch identify the link failure?If link failure detection > > is set to 'carrier",how will it identify the link failure.Please clarify > > If you are talking about bond configuration, when link failure > detection is in "carrier" mode, when carrier goes down on one of the > links in the bond, OVS uses a different link. >
_______________________________________________ discuss mailing list [email protected] http://openvswitch.org/mailman/listinfo/discuss
