Hi All, To test NSH feature in ovs (using custom ovs), I am trying to configure VxLan Tunnel between two hypervisors each running one VM using these commands. But whenever I provide an ip to br1 the internet connectivity to my host is lost. Also Vxlan with nsh shows up in the ovs-vsctl show command but VMs are not able to ping each other on different hosts.
On Host 1 #ovs Setup ovs-vsctl add-br br0 ovs-vsctl add-br br1 ovs-vsctl add-port br0 eth0 ifconfig eth0 0 && ifconfig br0 192.168.1.3 netmask 255.255.255.0 route add default gw 192.168.1.1 br0 ifconfig br1 10.1.2.10 netmask 255.255.255.0 #configuring VxLan sudo ovs-vsctl add-port br1 vxlan1 -- set interface vxlan1 type=vxlan options:remote_ip=192.168.1.4 options:key=0x5000 options:nsp=0x123456 options:nsi=44 options:npc=0x22000000 options:nsc=0x33000000 options:spc=0x44000000 options:ssc=0x5500000 -- Thanks and regards, Yogesh Pandey Mailto:yogesh.pand...@tcs.com =====-----=====-----===== Notice: The information contained in this e-mail message and/or attachments to it may contain confidential or privileged information. If you are not the intended recipient, any dissemination, use, review, distribution, printing or copying of the information contained in this e-mail message and/or attachments to it are strictly prohibited. If you have received this communication in error, please notify us by reply e-mail or telephone and immediately and permanently delete the message and any attachments. Thank you
_______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
