On 09/18/2011 08:26 PM, Hans Bezemer wrote:
On Sunday 18 September 2011, you wrote:
after you boot ro your memcard, you can try to flash the rootfs inside
linux: mtd.nn flash rootfs rootfs.ubi
Isn't this the correct command?
ubiformat /dev/mtd2 -f openwrt-xburst-qi_lb60-root.ubi
Hi Hans
yes. sorry. let's flash the whole mtd2 first. then ubiformat:
flash_eraseall /dev/mtd1 #this maybe not needed, but just for double check
ubiformat /dev/mtd2-f openwrt-xburst-qi_lb60-root.ubi
see if we get some bad block when run those two commands.
I tried the current xburst version but I got all kinds of dependency errors.
Since this is my main workhorse I'm quite conservative in manually compiling
new library versions especially when a fork has taken place (libusb). So I'm
going for the SD option first.
yes. sure
Hans Bezemer
_______________________________________________
Qi Hardware Discussion List
Mail to list (members only): [email protected]
Subscribe or Unsubscribe:
http://lists.en.qi-hardware.com/mailman/listinfo/discussion
