I just tried the following :
cut 2 lengths of headphone wire about 3 in. long. Then I stripped a
good length with a knife, finding that there was both a bronzey colored
wire and a reddish one. So I got my Motorola 3.7v 910 Mah battery with
disaligned contacts. I taped the ends of each wire to the correponding +
and - contacts of the battery- or so I assume since there were 4 of them
but the outer 2 seemed to be labeled + and - . then I threaded the other
2 ends around the corresponding little eyelets on the Ben. I pushed the
power button (having rotated the setup) and got nothing. Where did I go
wrong? I appreciate constructive criticism.
_______________________________________________
Qi Hardware Discussion List
Mail to list (members only): [email protected]
Subscribe or Unsubscribe:
http://lists.en.qi-hardware.com/mailman/listinfo/discussion
