Scott Ullrich wrote:
This was fixed right after b1.
Upgrade to http://www.pfsense.com/~sullrich/1.0-BETA1-TESTING-SNAPSHOT-1-29-06/
Is it possible with the pre beta snapshots to upgrade the 19 meg
embedded image of 1-25-06 with the 19 meg embedded image of 1-29-06
using the firmware page? About 7 megs gets transmitted and then I just
get a TCP reset(a log entry about var being filled up by lighttpd is
mentioned in the logs around the same time as the tcp reset).
I realize this is pre beta code but was hoping to avoid pulling the
device apart again and going through the setup wizard to restore the
backup config.
On 1/29/06, Randy B <[EMAIL PROTECTED]> wrote:
If some of you will recall, quite some time ago I complained that I
found that CARP was being transmitted on my untrusted interfaces between
a couple of test boxes in a lab instead of on their synchronization
interface; something that the rest of the list seemed to think a
--cut--
