Hi
I have an IPSEC tunnel configured to connect the network 170.60.x.x,
on side A, with network 189.19.x.x on side B.
LAN ---- Server A ---- INTERNET ---- Server B
10.0.0.0/8 189.19.x.x 170.60.x.x
The tunnel connection is established and the traffic between servers
go through the tunnel with no problems, the problem is when the
traffic came from LAN. Since the tunnel network is configured to my
WAN address range, SPD table doesn't has my lan network 10.0.0.0/8
configured, then traffic from lan to 170.60.x.x goes through wan
interface instead of enc0.
I know that is possible to do it using NAT on enc0 interface, but I
tried to configure this many ways without success.
Anybody knows how to make it works on pfSense, or if is it possible to do?
--
VinÃcius Coque
---------------------------------------------------------------------
To unsubscribe, e-mail: discussion-unsubscr...@pfsense.com
For additional commands, e-mail: discussion-h...@pfsense.com
Commercial support available - https://portal.pfsense.org
