quietdragon wrote: > I have successfully used PowerSwitchII plugin to control an amplifier > from an SB3. I was hoping to do something similar for an SBR setup. Presumably PowerSwitchII can't be used with the SB Radio's headphone output? Did I read somewhere once that the muting of the speaker was under software control (because the speaker goes through a different circuit, to make it mono, than the headphone jack)? If so, perhaps a revised version of PowerSwitchII could work?
In case you've not found it I came across an interesting article where someone made their over battery pack which may have useful information about the pin-outs (http://cms.diodenring.de/en/electronic/mikrocontroller/92-squeezebox) though it does look like the 3.3V is always on to me. ------------------------------------------------------------------------ Simon300's Profile: http://forums.slimdevices.com/member.php?userid=30835 View this thread: http://forums.slimdevices.com/showthread.php?t=97759 _______________________________________________ diy mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/diy
