lukejackson wrote: > > 2. It seemed to me the secondary beige board between the main board and > the display was related to turning the unit on/off. I unplugged the > cable between this board and the main board, turned the unit on and the > red light did not flash. As such, I believe the secondary board is > allowing power to pass to the main board.
I seem to recall that the beige board creates the high voltage for the display and that it is situated far from the DAC circuitry to minimize interference. The internal PSU must then be powering the beige board, which also is how I interpret the leads in the picture. The blinking LED might be indicating that the PSU senses that it is shorted, turns itself off (LED off) and then tries again (LED on). If the blinking stops when you remove the beige board, it might indicate that the short circuit is somewhere in the beige board. Is the Transporter capable of playing audio without the beige board (but with no display)? Best Regards, Gandhi not often enough well recorded and mastered cds *|* dbpoweramp with accuraterip *|* flac *|* fanless asrock z77e-itx intel i5-3570t *|* ubuntu 12.04.1 lts 32-bit *|* lms 7.8.0 *|* brutefirdrc 3.0 *|* transporter (balanced out) *|* thule ia252b *|* audio physic scorpio *|* no fancy cables. *+* also some booms. *+* harmony 525s for them all, including waking the server from s3. ------------------------------------------------------------------------ Gandhi's Profile: http://forums.slimdevices.com/member.php?userid=58909 View this thread: http://forums.slimdevices.com/showthread.php?t=100509 _______________________________________________ diy mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/diy
