paul- wrote: > Rpi has internal pull-up/down resistors, set by software. > > The safest way to wire the button is to set the resisors as pull-up, and > then connect the gpio pin to ground with the button. Do the same with > encodersÂ….connect the center to ground.
Ok, that's what I was leaning toward, but wasn't sure. > You can still get contacT bounce, but the software has debounce timers > in the setup. Ditto. Was pretty sure it was accounted for, but not 100% Thanks! Now just to get the time to put it together. ------------------------------------------------------------------------ ShaneC80's Profile: http://forums.slimdevices.com/member.php?userid=71859 View this thread: http://forums.slimdevices.com/showthread.php?t=107001
_______________________________________________ diy mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/diy
