Hi Joel,

Thank you for the early Rtgdir review. We took your main points as clarity
and scoping issues: what this document standardizes was not stated clearly
enough, and the relationship to the BGP work was left ambiguous.

We have now posted the -03 revision, which tries to address them:
https://datatracker.ietf.org/doc/draft-ietf-dmm-mup-architecture-03/

On the Standards Track question: this document standardizes the semantics
of MUP segments and routes and the behavior of MUP PEs and the MUP
controller; it does not define wire encodings. That follows the model of
architecture specifications such as the Segment Routing architecture [RFC
8402]. Keeping this document on the Standards Track also avoids a downref
problem for draft-ietf-bess-mup-safi, which normatively references this
architecture.

We agree that the -02 text made this harder to see: -02 did not cite
draft-ietf-bess-mup-safi at all, and described the BGP extensions "as an
example", which understandably read as if this document were defining them.
The -03 revision states the scope and the division of labour explicitly.
The BGP-MUP SAFI, NLRI, and MUP Extended Community encodings and IANA
assignments are specified in draft-ietf-bess-mup-safi; this document
defines only the semantics (what the community identifies and what metadata
it carries).

The main changes in -03 are:

   - Scope and deployment model are stated up front. The Abstract and the
   Introduction now say explicitly what the document defines (the architecture
   principles, the semantics of segments and routes, how the routes are
   distributed and resolved, and the behaviour required of a MUP PE and of a
   MUP Controller), that those definitions are normative, and that the
   document defines no wire encoding and makes no IANA request. The
   Introduction and Section 3 also give the deployment model before the
   procedures: a MUP network is typically deployed within a single
   administrative domain, with the discovery and session-transformed routes
   distributed over iBGP between the MUP PEs and the MUP-C, and Section 3
   explains why BGP is recommended to carry the routing information.
   - "MUP segment" is defined as a logical abstraction, not a portion of
   the network. Section 4 now opens with that definition and states that a
   segment is a symmetric abstraction: a segment is described, discovered and
   used in the same way at either end of a session, and the document does not
   characterise a segment by whether it sits on an access side or on a
   non-access side; such roles are decided by the deployment. The two segment
   types are distinguished only by whether reaching the segment requires
   interworking with a user plane protocol of a mobile service architecture.
   Section 4.1 clarifies that, for SRv6, a SID is not the segment itself: it
   identifies a forwarding behaviour executed at the MUP PE that hosts the
   segment.
   - The session information that the third principle of Section 3 talks
   about is now defined in the Terminology (with the F-TEID as the 3GPP
   example of a tunnel endpoint identifier), and the principle itself is
   written out as a full statement starting from that concrete picture. A
   short statement of the BGP division of labour is repeated in Section 3: the
   BGP extensions that realise the routes, including the BGP-MUP SAFI and the
   MUP Extended Community, are specified in draft-ietf-bess-mup-safi.
   - Section 5 defines the semantics of the MUP Extended Community only;
   its encoding and IANA allocations are in draft-ietf-bess-mup-safi. For the
   ISD route, Section 5.2 states that the community may be attached, and that
   an ISD route without one is treated as belonging to the default Interwork
   Segment.
   - Sections 6.1 and 6.2 describe the ST1 and ST2 routes in parallel
   terms. An ST1 route carries the prefix of a UE or MN; an ST2 route is keyed
   by the tunnel endpoint identifier of the session (the matching endpoint),
   and the destination endpoint is resolved through the segment discovery
   routes, as illustrated by the home-routed roaming example in Section 7.5.

We would welcome your view on whether this addresses the scoping questions
you raised, and on any remaining clarity issues.

Thanks again for the review.

Best regards,

--satoru



On Sun, Aug 16, 2026 at 10:25 AM Joel Halpern via Datatracker <
[email protected]> wrote:

> Document: draft-ietf-dmm-mup-architecture
> Title: Mobile User Plane Architecture for Distributed Mobility Management
> Reviewer: Joel Halpern
> Review result: Not Ready
>
> Hello
>
> I have been selected to do a routing directorate “early” review of this
> draft.
> https://datatracker.ietf.org/doc/draft-ietf-dmm-mup-architecture/
>
> The routing directorate will, on request from the working group chair,
> perform
> an “early” review of a draft before it is submitted for publication to the
> IESG. The early review can be performed at any time during the draft’s
> lifetime
> as a working group document. The purpose of the early review depends on the
> stage that the document has reached.
>
> This review is provided with the understanding that the draft is
> approaching
> completion.
>
> For more information about the Routing Directorate, please see
> https://wiki.ietf.org/en/group/rtg/RtgDir
>
> Document: draft-ietf-dmm-mup-architecture-02.txt
> Reviewer: Joel Halpern
> Review Date: 15-Aug-2026
> Intended Status: Proposed Standard
>
> Summary:
> Choose from this list...
>
> I have significant concerns about this document. It needs more work before
> being submitted to the IESG.  I believe most of these issues are matters of
> explanatory text and grammar, not issues of technical flaw.  But it is
> hard to
> be certain.  There are also issues of appropriateness of scoping as it
> seems to
> define BGGP procedures.
>
> Comments:
>
> The document describes an alternative architecture for a mobility
> infrastructure.  It describes it as being related to the 3GPP
> architecture, and
> attempts to use 3GPP terms appropriately.  However, the document is quite
> hard
> to read and understand.
>
> Major Issues:
>     It is unclear to this reviewer if this draft is actu
> Give as much context information as possible with your comments (e.g.,
> section
> numbers, paragraph counts).ally informational or standards track.  It
> describes
> an architecture.  It describes that there need to be protocol extensions to
> support that architecture.  Presumably for reasons of scoping and
> appropriate
> responsibility, this document does not standardize protocol extensions.  So
> what is being standardized?  The requirements are stated to be taken from
> another document.
>
>     It is also odd, in a document that is not defining protocol
> extensions, to
>     provide example extensions.  It seems to invite readers to treat those
> as
>     extensions to be used, even though they are not formally adopted by
> this
>     document.  This becomes even more confusing when the document proceeds
> to
>     state that it defines a MUP extended community.  There are very
> specific
>     BGP rules limiting how extended communities can be defined, and as far
> as I
>     know it needs to be done by the IDR working group.
>
>     Apparently, the architecture intends to require the use of BGP.  Such a
>     requirement is understandable.  But it was not stated before the text
>     suddenly introduced reliance on extended communities.  And then in
> section
>     6 introduces further BGP dependence.  I suspect that the assumption is
> that
>     the PE devices correspond to the AS boundary devices, and this is all
>     assumed to be used in iBGP.  But I can't find the text that explains
> that
>     before it is relied upon.
>
>     As a reader, I am quite confused as to what constitutes a MUP segment.
>     From some of the diagrams, it seems to be a portion of the network,
>     delimited somehow.  On the other hand, there is text that an SRv6 SID
> can
>     correspond to a MUP segment.   An SRv6 SID identifies a node, not a
> portion
>     of the network.  (Yes, this is a general issue with segment routing
> where
>     we often treat the node as if it represents the path portion that
>     terminates there.  Within an SR SID list of any type, this can usually
> be
>     understood.  The usage here is not in the context of a SID list, so I
> am
>     unsure what is meant.)  This makes review of the subsequent discussion
> of
>     discovery somewhat more difficult.
>
> Minor Issues:
>     In section 3 on architectural principles, there appear to be
> grammatical
>     problems in the core statements of the principles.  This is most easily
>     seen in the third principle where the text starts with the apparent
>     sentence "The third principle is that transforming session information
> to
>     routing information."  That is neither a sentence nor a principle.
>
>     I found the explanation in section 4 of the difference between a direct
>     segment and an interworking segment very hard to parse.  I am not
> confident
>     enough of my understanding to suggest specific new text.  I strongly
> urge
>     that it be revised for English clarity.
>
>     In section 6, section 6.1 states that type 1 information is for
> carrying
>     addresses of nodes to be reached over the access network.  I would then
>     expect that type 2 information is for carrying information abut
>     destiantions / prefixes reach over the non-access network.  As far as
> I can
>     tell the text does not say that, but leaves the reader guessing as to
> what
>     type 2 information is for.
>
> Nits:
>
>
>
>
_______________________________________________
dmm mailing list -- [email protected]
To unsubscribe send an email to [email protected]

Reply via email to