[dnb-prod] Re: MIDI Controllers and filters help!

[Tom Sprynczynatyk]

The filter stays shut because your sequencer (Logic?) thinks it still should be shut, because you haven't told it otherwise.  MIDI keeps doing the last thing you tell it, so that's why the filter is still at 0.  Just put a CC at the very beginning of the next part setting the filter to all the way open again, and you should be fine.
 

Auraphage

[EMAIL PROTECTED] wrote:

OK so I've got a new tune on the go and I want to add some nice filter sweeps to some drum parts. I assign Controller 12 to filter cutoff to the drum group in the emu.
I then draw in the ramp for the part so the filter ( low pass ) gradualy shuts toward the end of the part so the drums fade out. It does this fine except the fucking filter stays shut for the next part where I want it to be fully open again ( and theres no CC data in the new parts to tell it to stay shut. Ive tried MIDI preferences and "reset Controller 12 on part stop" The logical thing to do would just be record it in while playing, but my hand aint as steady as yours so I'd rather draw em in seen! Any ideas wots goin on?
Easy,
Will ---
Drum&Bass Arena Producers Discussion List http://www.breakbeat.co.uk
You are currently subscribed to dnb-prod as: [EMAIL PROTECTED]
To unsubscribe send a blank email to [EMAIL PROTECTED]

---
Drum&Bass Arena Producers Discussion List http://www.breakbeat.co.uk
You are currently subscribed to dnb-prod as: archive@jab.org
To unsubscribe send a blank email to [EMAIL PROTECTED]