On Wed, 2021-02-17 at 11:26 -0700, Gabe Stanton via Dng wrote: > On Tue, 2021-02-16 at 07:55 -0500, Steve Litt wrote: > > Thanks Ralph, > > I had left them both out, but putting them in didn't change > > thesymptom. I tried with only auto eth0, and that didn't change > > thesymptom either. > > Thanks, > > SteveT > > Steve Litt > > > Just want to throw this out there in case it helps even a bit. > > I have a devuan vm running on a devuan host, I believe virt-manager > handled network setup for me, but in any case, below are the contents > of my /etc/network/interfaces files from both the host and the vm. > (notice on the host they have br0 config'd here instead of eth0, > don't know if you were referring to that file on the host or the VM.) > > Host: > > auto br0 > iface br0 inet dhcp > bridge-ports eth0 > > > > > > VM: > # This file describes the network interfaces available on your system > # and how to activate them. For more information, see interfaces(5). > > source /etc/network/interfaces.d/* > > # The loopback network interface > auto lo > iface lo inet loopback > > # The primary network interface > allow-hotplug eth0 > iface eth0 inet dhcp > > > > > anyway, hope that helps. > > Gabe > > > > > _______________________________________________Dng mailing > [email protected] > https://mailinglists.dyne.org/cgi-bin/mailman/listinfo/dng
Just to be clear, my VM ip address is as you would like yours to be, it is a dhcp address from the pool on my router. So my host is 192.168.1.x and my vm is 192.168.1.y, and the VM is accessible from the network.
_______________________________________________ Dng mailing list [email protected] https://mailinglists.dyne.org/cgi-bin/mailman/listinfo/dng
