Hi Vivek,
I looked a little bit into this.
Actually the files are also written when publishing in Oxygen, but they
are not written in the place where you expect, you should look for them
in the Oxygen installation folder.
If you edit the Oxygen transformation scenario, click the "Parameters"
button, there is a transformation parameter called "man.output.base.dir"
which you can set to "${cfd}/man/".
And there is another parameter called "man.output.in.separate.dir" which
should be set to "1".
These parameters should direct the publishing to output files in a
folder next to the XML file.
Regards,
Radu
Radu Coravu
<oXygen/> XML Editor
http://www.oxygenxml.com
On 2/7/2019 11:54 PM, Vivek Ghosh wrote:
Hi,
I am trying to convert Docbook to man pages from Oxygen using Saxon 6.5
with available Docbook.xsl
(<oxygen_install_directory>>frameworks>>docbook>>xsl>>manpages)
From the log file (see below) I can see that transformation is
successfully completed but the man pages are not generated.
*/System ID: D:\Oxygen_Download\Oxygen XML Author
20\frameworks\docbook\xsl\html\chunker.xsl/*
*/Description: [Saxon6.5.5] Note: Writing Intro.1M/*
*/Start location: 111:0/*
*/ /*
*/System ID: D:\Oxygen_Download\Oxygen XML Author
20\frameworks\docbook\xsl\html\chunker.xsl/*
*/Description: [Saxon6.5.5] Note: Writing intro.1M (soelim stub)/*
*/Start location: 111:0/*
To test the docbook I tried using xsltproc which generates the man pages
without any issues confirming that docbook is all good.
Any insight will be greatly appreciated.
Thanks,
Vivek
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
