An interesting question. there are a few solutions I think.THe first one is if the wings are on, it is possible to put a stand under the wing tip and lift the wheel clear. (Tho probable not the best idea ) The best would be to remove the fiberglass cover between the U/C legs which will clear access to the 2 U/C attach straps on each side. Then use a length of timber to pick up the 4 strap mounting rod ends protruding. Then put a jack under that, lifting the fuse. I would suggest when the wheel is off, check the bearings and the seals to prevent water ingress. The seals are compressed between 2 spacers and replacements can be made from leather. The early Dimona’s used metal hydraulic lines which I found quite tricky to both undo and do up again. Hope that is of some help
Ian Williams New Zealand Sent from my iPad > On 22 Sep 2024, at 09:23, Tomasz Dzikuć <[email protected]> wrote: > > > Dear Dimona users, > > We need to replace the main tire. > > We are wondering how to lift the Dimona to be able to remove the wheel. > > Hydraulic car jacks are not suitable (too low lifting height). > > We also cannot find information about where it has reinforced points, hooks > that can be used as support points. > > Maybe you have some experience in this area? > > Tomasz Dzikuc > > TMG Team > AZL Zielona Gora > Poland >
