Hi!
I just wanted to install a fresh FEniCS unstable version on my
snowleopard (no mpi tricks this time :) but I ran into a couple of
problems. This is the first one:
Despite the fact that petsccore is used in the snowleopard.platform
petsc does the FortranMPICheck and aborting because of the missing
mipf90 compiler.
I could remedy this by adding --with-fc=0 to the package file but was
wondering if somebody else has run into the problem. If so, I would
suggest to add the above mentioned flag to the package file.
Here is my error message:
Unpacking petsc-3.1-p7
Building petsc-3.1-p7
===============================================================================
Configuring PETSc to compile on your system
===============================================================================
===============================================================================
WARNING! Compiling PETSc with no debugging, this should
only be done for timing and production
runs. All development should
be done when configured using
--with-debugging=1
===============================================================================
TESTING: FortranMPICheck from
config.packages.MPI(config/BuildSystem/config/packages/MPI.py:636)
*******************************************************************************
UNABLE to CONFIGURE with GIVEN OPTIONS (see configure.log
for details):
-------------------------------------------------------------------------------
Fortran error! mpi_init() could not be located!
*******************************************************************************
Failure with exit status: 1
Exit message: There was a problem configuring petsc-3.1-p7.
Cheers,
--
André Massing email: [email protected]
Ph.D. student mobile: +47 469 57 401
Simula Research Laboratory
NO-1367 Fornebu, Norway
_______________________________________________
Mailing list: https://launchpad.net/~dorsal
Post to : [email protected]
Unsubscribe : https://launchpad.net/~dorsal
More help : https://help.launchpad.net/ListHelp
