::Some more items that are missing
From the .rtf file
These routines are interrupt handlers, and the last routine is code to
write a byte of data to the flash on a Silabs 8051 processor.
You will notice that the line "References, and . " Don't have anything
listed.. in the first case it should be
"References bttn1_debounce and bcount" OR since this is an embedded
project, EX0 is defined in a file that was not processed, but represents a
specific bit in a specific register,
so it should also be included, even though it is not listed anywhere other
than within the body of this code, it should be picked up because of that.
It is not a local
it is a global, but doxygen does not have knowledge of it.
but it *is* referenced within the function.....
References:
bttn1_debounce
EX0
bcount
void button_scan_interrupt_1 ()
Definition at line 5719 of file xxx.
References , and .
5720 {
5721 EX0=0;// disable any further interrupts from this pin to let
bouncing settle
5722 bttn1_debounce=20; // 20 miliseconds
5723 bcount=0; // start the 2 x per second
counter at 0
5724 }
::void button_scan_interrupt_2 ()
Definition at line 5734 of file xxx.
References , and .
5735 {
5736 EX1=0;// disable any further intterupts from this pin to let
bouncing settle
5737 bttn2_debounce=20; // 20 miliseconds
5738 bcount=0; //
5739 }
::char erase_flash (unsigned char * page_address)
<<<<<<<<<<<<<<<<<<<<<<<<????????????????? This got listed but without
anything else.
::void FLASH_ByteWrite (unsigned int addr, char byte)
Definition at line 8420 of file xxx.
References .
Referenced by , and .
8421 {
8422 saved_ie=IE;
8423 EA = 0; // disable interrupts
8424 PSCTL = 0x00; // MOVX writes target XRAM to keep
interrupt from happening
8425 EA=0;
8426 RSTSRC = 0x02; // enable VDD monitor as a
reset source
8427 FLKEY = 0xa5; // 1st FLASH key sequence
8428 FLKEY = 0xf1; // 2nd FLASH key sequence
8429 PSCTL = 0x01; // MOVX writes target FLASH memory
8430 ((unsigned char volatile xdata *) 0)[addr]=byte;
8431 PSCTL = 0x00; // MOVX writes target XRAM
8432 IE=saved_ie;
8433 }
Again, saved_ie is a global, so not sure why it got missed.
This function is called by configure_me, which is in turn called from main.
It is also called by main in a different place,
The caller graph which could not be pasted here, shows
main calling configure_me and configure_me calling FLASH_ByteWrite, AND it
shows a line from main directly to FLASH_ByteWrite, so the caller graph is
correct.
Based on this, the lines should look like:
void FLASH_ByteWrite (unsigned int addr, char byte)
Definition at line 8420 of file medbest_310_o_split.c.
References saved_ie
Referenced by configure_me and main.
Why is this happening
------------------------------------------------------------------------------
_______________________________________________
Doxygen-users mailing list
Doxygen-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/doxygen-users
