>Date: Mon, 01 Jun 1998 09:40:30 -0700
>From: Patrick Panzera <[EMAIL PROTECTED]>
>To: [EMAIL PROTECTED]
>Subject: Re: DFLY: Cutting metal with a wood router
>Reply-To: [EMAIL PROTECTED]
>Yes I am. But I'm intrigued with the idea of eliminating the
>motion changers. I'm using dual side sticks and they
>interconnect in the center, by way of bell cranks. They control
>a center torque tube, that acts as the center stick. Aft of the
>seatback b/head, there is no difference between the side sticks
>or the center stick. I've therefore decided to make the motion
>change, in the interconnection of the side sticks to the center
>torque tube.
>
>Pat
Pat,
How did you fit in the fuel fuller point if you have sticks on both
sides? Is there enough room for the filler point and the control
pushrods etc?
Bill Ginn
[EMAIL PROTECTED]
Sydney Australia
02-94188895
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
-----------------------------------------------------------------------------
dragonlist is hosted courtesy of Interstice Inc., a provider of reasonably
priced virtual domain hosting for the world, and dedicated circuit and
dialup for Silicon Valley. http://www.interstice.com (408) 369-4490
