"Floyd Sense" <[EMAIL PROTECTED]> made an utterance to the drakelist gang
----------------------------------------------------------------------
On my TR7, I have the version 2 pre-driver board. On my board, the resistor
R2209 that's in parallel with the adjustment pot has been removed. I don't
recall seeing anything about that in any of the TR7 info I've found on the
web. Since that was a 100 ohm resistor in parallel with the 100 ohm pot,
the result is that the pot now produces an adjustment range of 0 to 100
ohms, whereas with R2209 in place the range would be 0 to 50 ohms. One
alignment note from Drake suggested setting the adjustment pot to 50%, which
of course produces a different result with the resistor clipped. Any
comments on this?
73, Floyd - K8AC
----------------------------------------------------------------------
Submissions: [email protected]
Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body
Hopelessly Lost: [EMAIL PROTECTED] - help in body of message
Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net
----------------------------------------------------------------------
