That is most likely the pin going past the stop. When the spring-loaded
plunger for the stop gets gunked up from old grease, it doesn't engage
with the pin to STOP roatation at the ends.
If the stop IS working properly, the plunger -gear alignment may be off
slightly allowing the plunger to start advancing a little too early so
it nicks the pin one turn before the full stop.
To understand this, you probably need to watch the stop in action.
Should be no clicking at 0 and 500.
FWIW
Curt
KU8L
On 11/22/2011 12:55 AM, Neil M Califano wrote:
What is the clicking sound I hear when the R4A PTO is tuned past the 0 and 500
Khz? Is this a mechanical warning not to tune so close to the edge of travel?
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
