I just recently obtained an R-4C, made some upgrades to it, and aligned it. It
is working very well with one small issue:
On all bands, if I set the frequency to the calibrator at the low end, at the
high end the dial readout is high by one or more khz when set to the calibrator
(depending on the band width). I assume the issue is with the pto, but since I
have had little experience with the R-4C, I would like suggestions about the
easiest way to correct the problem before I dig into anything.
Note: I have checked the calibrator with other frequency standards, and it is
on the money.
Thanks,
Hank
_______________________________________________
Drakelist mailing list
[email protected]
http://mailman.zerobeat.net/mailman/listinfo/drakelist
