Rohit Upadhyay wrote:
Hello,
How is pre-existing volume user data handled when DRBD module is
loaded? Does it copy existing volume data to remote storage replica?
Or it works only on new DRBD virtual block device?
If a volume is already existing, does it replicate blocks such that
running applications are not impacted?
i'm gonna make a few assumptions here. i'm assuming you have a server
with a disk that has your existing data. and that you are setting up
another server with a similarly sized disk that you want to replicate
data from the first server to this disk. here are some pointers and
suggestions about doing this.
an existing volume can be converted to a drbd volume without any loss of
data, but there are a few things to be aware of. first and foremost is
you need to make sure you pick the right disk to be the primary disk the
first time you bring up drbd. last thing you want is to accidentally
make the new blank drive the primary and have everything get copied from
the blank drive over to your drive with data and overwriting everything.
if you are following the documentation on drbd.org, make sure you follow
the instructions in "The initial device synchronization" of chapter 5 on
your server with the existing data. when it does the initial sync, it
will copy all of the blocks and data from the original volume to the new
volume on the remote server.
the other gotcha to be aware of is that drbd needs some space to store
its metadata. most people put this at the end of the block device with
the data. but i'm guessing when you formatted your volume you didn't
leave room at the end of the device for stuff like this. if this is the
case, then you are going to need to either put the drbd metadata on
another block device or make room at the end of the block device (either
shrinking the filesystem or increasing the size of the block device if LVM).
as for doing this while the system and apps on the system are online, it
definitely can be done. things might be a little slow cause drbd is
using some disk IO to do the replication. there isn't a technical reason
you can't do it. after setting things up though, you should adjust your
mount points so that the primary node is mounting the /dev/drbdX device
instead of mounting the raw block device. that can be done with just a
few seconds of downtime after drbd is set up and it doesn't have to
happen immediately. you just need to make sure things get changed so
that you aren't using the raw block device all the time cause that can
really confuse drbd and mess thing up in the future.
so to re-cap. you can convert an existing volume to a drbd volume
without losing data and drbd will just copy the data from one machine to
the other. and you can do this while the system is online.
hope that was helpful.
mike
_______________________________________________
drbd-user mailing list
[email protected]
http://lists.linbit.com/mailman/listinfo/drbd-user
