Dan, One thing I would like to add (well two actually).
As someone else pointed out, it should end in 0 in the guide example because it is supposed to be your network address not a host address. It could be something else depending upon your specific network config but assuming as you mentioned (it does begin with a 192 and we assumed it is a default 24 bit subnet) then 0 is correct. Second should you choose to subnet 23 bits or less with a class C network do not use the .0 addresses for hosts in a mixed environment because many non linux OS's will not talk to that address even though it's a technically valid supernet (win xp for example). Hope that helps someone! Jake ----- Reply message ----- From: "Dan Barker" <[email protected]> To: <[email protected]> Subject: [DRBD-user] Corosync Configuration Date: Mon, Jun 11, 2012 4:19 pm Off OP's topic, but a correction. -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Pascal BERTON Sent: Thursday, June 07, 2012 1:29 PM To: 'Jake Smith'; [email protected] Subject: Re: [DRBD-user] Corosync Configuration I also used this manual to startup, I agree with Jake, that's a typo. Apart from that, William, your "bindnetaddr" parameter should not end with a "0", it's supposed to be the IP address your local host/node will use to monitor its peers. Instead, replace it by the IP address your server has on network 192.168.1.0. <snip> Although it is extremely likely that 'should not end with a "0"' is a correct statement on this network (it does begin with a 192 and we assumed it is a default 24 bit subnet), it is not a requirement. The OP didn't post his subnet specification. Any network with a subnet mask of 23 bits or less can have a final octet of Zero be a host. In a class A subnet, there is one network (ends with a .0.0.0), 255 hosts that end with two zeros (.0.0) and 65,280 hosts that end with a single zero .0). I normally wouldn't make this minor a correction, but Pascal then said "The cool thing (to me) is that I learn something more everyday on this ML..." Dan _______________________________________________ drbd-user mailing list [email protected] http://lists.linbit.com/mailman/listinfo/drbd-user
_______________________________________________ drbd-user mailing list [email protected] http://lists.linbit.com/mailman/listinfo/drbd-user
