Hi, On 01/24/2013 06:04 PM, Jacek Osiecki wrote:
umount: /dev/drbd0: not mounted all: Failure: (127) Device minor not allocated ERROR: Module drbd is in use .
That looks very weird. I don't quite remember how to cleanly unmount an ocfs2. Make sure you can start and stop both the FS and DRBD while running. If you got that figured out, apply that to your boot sequence.
Any ideas? Am I getting it right that if drbd would stop well before network shutdown, the node would reconnect as primary-primary after reboot?
Absolutely. Of course, mounting ocfs2 must not happen until the drbd connection is established and the local node promoted. (More specifically - make sure your local node does not promote itself before it's connected.)
It's so in my linux distro... I got much newer kernel but seems that still it's only 8.3 drbd in it.
You should build your own userland (package) then, although even that is not always trivial.
I'm using it for a HA configuration, where two machines are serving the same data through WWW server. Machines are set behind a load balancer. It would be nice if after rebooting any node, it would refresh its data from the other node and then start serving data as usual...
That's what happens, but honestly - this is not exactly a high speed setup. Have you done benchmarks? Gluster might be a more appropriate solution, even though the consistency is probably better with ocfs/drbd.
I notice you chose to ignore my most pressing point: stonith is mandatory for dual-primary operation. Do you have a good reason to not use pacemaker?
Cheers, Felix _______________________________________________ drbd-user mailing list [email protected] http://lists.linbit.com/mailman/listinfo/drbd-user
