On 2018-10-19 11:16 a.m., Bryan K. Walton wrote:
On Thu, Oct 18, 2018 at 04:47:53PM +1100, Adi Pircalabu wrote:
Why aren't you using Ethernet bonding?
Thanks Adi,
We are rethinking our network configuration. We may do our replication
through a directly cabled and bonded connection, and bypass our
switches. This would simplify our drbd configuration.
We've used mode=1 (active-passive) bonding under DRBD for years across
numerous installs and countless test and prod failures without issue. We
still run through switches (link1 to switch 1, link2 to switch 2,
hitless failover config on the stack). We can and have failed NICs,
cables and switches without interruption.
We've documented this setup here;
https://www.alteeve.com/w/Build_an_m2_Anvil!#Logical_Map.3B_Hardware_And_Plumbing
digimer
_______________________________________________
drbd-user mailing list
[email protected]
http://lists.linbit.com/mailman/listinfo/drbd-user
