Change 'pixes' to 'pixels'
Change 'enabel' to 'enable'
Change 'enabeling' to 'enabling'
Signed-off-by: Yannick Guerrini <yguerrini at tomshardware.fr>
---
drivers/gpu/drm/drm_modes.c | 4 ++--
drivers/gpu/drm/i2c/adv7511.c | 2 +-
2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/gpu/drm/drm_modes.c b/drivers/gpu/drm/drm_modes.c
index 487d0e3..2cca85f 100644
--- a/drivers/gpu/drm/drm_modes.c
+++ b/drivers/gpu/drm/drm_modes.c
@@ -278,7 +278,7 @@ struct drm_display_mode *drm_cvt_mode(struct drm_device
*dev, int hdisplay,
hblank = drm_mode->hdisplay * hblank_percentage /
(100 * HV_FACTOR - hblank_percentage);
hblank -= hblank % (2 * CVT_H_GRANULARITY);
- /* 14. find the total pixes per line */
+ /* 14. find the total pixels per line */
drm_mode->htotal = drm_mode->hdisplay + hblank;
drm_mode->hsync_end = drm_mode->hdisplay + hblank / 2;
drm_mode->hsync_start = drm_mode->hsync_end -
@@ -1209,7 +1209,7 @@ EXPORT_SYMBOL(drm_mode_connector_list_update);
* <xres>x<yres>[M][R][-<bpp>][@<refresh>][i][m][eDd]
*
* The intermediate drm_cmdline_mode structure is required to store additional
- * options from the command line modline like the force-enabel/disable flag.
+ * options from the command line modline like the force-enable/disable flag.
*
* Returns:
* True if a valid modeline has been parsed, false otherwise.
diff --git a/drivers/gpu/drm/i2c/adv7511.c b/drivers/gpu/drm/i2c/adv7511.c
index fa140e0..61aa824 100644
--- a/drivers/gpu/drm/i2c/adv7511.c
+++ b/drivers/gpu/drm/i2c/adv7511.c
@@ -573,7 +573,7 @@ static void adv7511_encoder_dpms(struct drm_encoder
*encoder, int mode)
* goes low the adv7511 is reset and the outputs are disabled
* which might cause the monitor to go to standby again. To
* avoid this we ignore the HDP pin for the first few seconds
- * after enabeling the output.
+ * after enabling the output.
*/
regmap_update_bits(adv7511->regmap, ADV7511_REG_POWER2,
ADV7511_REG_POWER2_HDP_SRC_MASK,
--
1.9.5.msysgit.0
