Hi Wolfram,
Thank you for the patch.
On Monday 04 January 2016 03:33:47 Wolfram Sang wrote:
> From: Wolfram Sang <wsa+renesas at sang-engineering.com>
>
> Fix this typo, consequently used over both files :)
>
> Signed-off-by: Wolfram Sang <wsa+renesas at sang-engineering.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
> ---
> drivers/gpu/drm/i2c/adv7511.c | 22 +++++++++++-----------
> drivers/gpu/drm/i2c/adv7511.h | 12 ++++++------
> 2 files changed, 17 insertions(+), 17 deletions(-)
>
> diff --git a/drivers/gpu/drm/i2c/adv7511.c b/drivers/gpu/drm/i2c/adv7511.c
> index 50a861b12346c4..c03c1ea53fd042 100644
> --- a/drivers/gpu/drm/i2c/adv7511.c
> +++ b/drivers/gpu/drm/i2c/adv7511.c
> @@ -378,16 +378,16 @@ static void adv7511_power_on(struct adv7511 *adv7511)
> }
>
> /*
> - * Per spec it is allowed to pulse the HDP signal to indicate that the
> + * Per spec it is allowed to pulse the HPD signal to indicate that the
> * EDID information has changed. Some monitors do this when they wakeup
> - * from standby or are enabled. When the HDP goes low the adv7511 is
> + * from standby or are enabled. When the HPD goes low the adv7511 is
> * reset and the outputs are disabled which might cause the monitor to
> - * go to standby again. To avoid this we ignore the HDP pin for the
> + * go to standby again. To avoid this we ignore the HPD pin for the
> * first few seconds after enabling the output.
> */
> regmap_update_bits(adv7511->regmap, ADV7511_REG_POWER2,
> - ADV7511_REG_POWER2_HDP_SRC_MASK,
> - ADV7511_REG_POWER2_HDP_SRC_NONE);
> + ADV7511_REG_POWER2_HPD_SRC_MASK,
> + ADV7511_REG_POWER2_HPD_SRC_NONE);
>
> /*
> * Most of the registers are reset during power down or when HPD is low.
> @@ -421,9 +421,9 @@ static bool adv7511_hpd(struct adv7511 *adv7511)
> if (ret < 0)
> return false;
>
> - if (irq0 & ADV7511_INT0_HDP) {
> + if (irq0 & ADV7511_INT0_HPD) {
> regmap_write(adv7511->regmap, ADV7511_REG_INT(0),
> - ADV7511_INT0_HDP);
> + ADV7511_INT0_HPD);
> return true;
> }
>
> @@ -446,7 +446,7 @@ static int adv7511_irq_process(struct adv7511 *adv7511)
> regmap_write(adv7511->regmap, ADV7511_REG_INT(0), irq0);
> regmap_write(adv7511->regmap, ADV7511_REG_INT(1), irq1);
>
> - if (irq0 & ADV7511_INT0_HDP && adv7511->encoder)
> + if (irq0 & ADV7511_INT0_HPD && adv7511->encoder)
> drm_helper_hpd_irq_event(adv7511->encoder->dev);
>
> if (irq0 & ADV7511_INT0_EDID_READY || irq1 & ADV7511_INT1_DDC_ERROR) {
> @@ -648,10 +648,10 @@ adv7511_encoder_detect(struct drm_encoder *encoder,
> if (adv7511->status == connector_status_connected)
> status = connector_status_disconnected;
> } else {
> - /* Renable HDP sensing */
> + /* Renable HPD sensing */
> regmap_update_bits(adv7511->regmap, ADV7511_REG_POWER2,
> - ADV7511_REG_POWER2_HDP_SRC_MASK,
> - ADV7511_REG_POWER2_HDP_SRC_BOTH);
> + ADV7511_REG_POWER2_HPD_SRC_MASK,
> + ADV7511_REG_POWER2_HPD_SRC_BOTH);
> }
>
> adv7511->status = status;
> diff --git a/drivers/gpu/drm/i2c/adv7511.h b/drivers/gpu/drm/i2c/adv7511.h
> index 6599ed538426d6..38515b30cedfc8 100644
> --- a/drivers/gpu/drm/i2c/adv7511.h
> +++ b/drivers/gpu/drm/i2c/adv7511.h
> @@ -90,7 +90,7 @@
> #define ADV7511_CSC_ENABLE BIT(7)
> #define ADV7511_CSC_UPDATE_MODE BIT(5)
>
> -#define ADV7511_INT0_HDP BIT(7)
> +#define ADV7511_INT0_HPD BIT(7)
> #define ADV7511_INT0_VSYNC BIT(5)
> #define ADV7511_INT0_AUDIO_FIFO_FULL BIT(4)
> #define ADV7511_INT0_EDID_READY BIT(2)
> @@ -157,11 +157,11 @@
> #define ADV7511_PACKET_ENABLE_SPARE2 BIT(1)
> #define ADV7511_PACKET_ENABLE_SPARE1 BIT(0)
>
> -#define ADV7511_REG_POWER2_HDP_SRC_MASK 0xc0
> -#define ADV7511_REG_POWER2_HDP_SRC_BOTH 0x00
> -#define ADV7511_REG_POWER2_HDP_SRC_HDP 0x40
> -#define ADV7511_REG_POWER2_HDP_SRC_CEC 0x80
> -#define ADV7511_REG_POWER2_HDP_SRC_NONE 0xc0
> +#define ADV7511_REG_POWER2_HPD_SRC_MASK 0xc0
> +#define ADV7511_REG_POWER2_HPD_SRC_BOTH 0x00
> +#define ADV7511_REG_POWER2_HPD_SRC_HPD 0x40
> +#define ADV7511_REG_POWER2_HPD_SRC_CEC 0x80
> +#define ADV7511_REG_POWER2_HPD_SRC_NONE 0xc0
> #define ADV7511_REG_POWER2_TDMS_ENABLE BIT(4)
> #define ADV7511_REG_POWER2_GATE_INPUT_CLK BIT(0)
--
Regards,
Laurent Pinchart
