Hi, Am 02.06.20 um 21:31 schrieb Eric Anholt: > On Tue, Jun 2, 2020 at 8:02 AM Dave Stevenson > <dave.steven...@raspberrypi.com> wrote: >> Hi Maxime and Eric >> >> On Tue, 2 Jun 2020 at 15:12, Maxime Ripard <max...@cerno.tech> wrote: >>> Hi Eric >>> >>> On Wed, May 27, 2020 at 09:54:44AM -0700, Eric Anholt wrote: >>>> On Wed, May 27, 2020 at 8:50 AM Maxime Ripard <max...@cerno.tech> wrote: >>>>> The VIDEN bit in the pixelvalve currently being used to enable or disable >>>>> the pixelvalve seems to not be enough in some situations, which whill end >>>>> up with the pixelvalve stalling. >>>>> >>>>> In such a case, even re-enabling VIDEN doesn't bring it back and we need >>>>> to >>>>> clear the FIFO. This can only be done if the pixelvalve is disabled >>>>> though. >>>>> >>>>> In order to overcome this, we can configure the pixelvalve during >>>>> mode_set_no_fb, but only enable it in atomic_enable and flush the FIFO >>>>> there, and in atomic_disable disable the pixelvalve again. >>>> What displays has this been tested with? Getting this sequencing >>>> right is so painful, and things like DSI are tricky to get to light >>>> up. >>> That FIFO is between the HVS and the HDMI PVs, so this was obviously >>> tested against that. Dave also tested the DSI output IIRC, so we should >>> be covered here. >> DSI wasn't working on the first patch set that Maxime sent - I haven't >> tested this one as yet but will do so. >> DPI was working early on to both an Adafruit 800x480 DPI panel, and >> via a VGA666 as VGA. >> HDMI is obviously working. >> VEC is being ignored now. The clock structure is more restricted than >> earlier chips, so to get the required clocks for the VEC without using >> fractional divides it compromises the clock that other parts of the >> system can run at (IIRC including the ARM). That's why the VEC has to >> be explicitly enabled for the firmware to enable it as the only >> output. It's annoying, but that's just a restriction of the chip. > I'm more concerned with "make sure we don't regress pre-pi4 with this > series" than "pi4 displays all work from the beginning"
unfortuntely i can confirm this. With this patch series (using Maxime's git repo with multi_v7_defconfig) my Raspberry Pi 3 B hangs up while starting X (screen stays black, heartbeat stops, no more output at the debug UART). AFAIR v2 didn't had this issue. Stefan > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-ker...@lists.infradead.org > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel _______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/dri-devel
