It is possible to set a flag in the struct mipi_dsi_device so the panel is handled in low power (LP) mode. Some displays only support this mode and it is also good for testing.
Cc: [email protected] Cc: Stephan Gerhold <[email protected]> Signed-off-by: Linus Walleij <[email protected]> --- drivers/gpu/drm/mcde/mcde_dsi.c | 10 ++++++---- 1 file changed, 6 insertions(+), 4 deletions(-) diff --git a/drivers/gpu/drm/mcde/mcde_dsi.c b/drivers/gpu/drm/mcde/mcde_dsi.c index 76fecd7ab658..e335041e6e90 100644 --- a/drivers/gpu/drm/mcde/mcde_dsi.c +++ b/drivers/gpu/drm/mcde/mcde_dsi.c @@ -830,10 +830,11 @@ static void mcde_dsi_start(struct mcde_dsi *d) /* Command mode, clear IF1 ID */ val = readl(d->regs + DSI_CMD_MODE_CTL); /* - * If we enable low-power mode here, with - * val |= DSI_CMD_MODE_CTL_IF1_LP_EN + * If we enable low-power mode here, * then display updates become really slow. */ + if (d->mdsi->mode_flags & MIPI_DSI_MODE_LPM) + val |= DSI_CMD_MODE_CTL_IF1_LP_EN; val &= ~DSI_CMD_MODE_CTL_IF1_ID_MASK; writel(val, d->regs + DSI_CMD_MODE_CTL); @@ -922,10 +923,11 @@ static void mcde_dsi_bridge_pre_enable(struct drm_bridge *bridge) /* Command mode, clear IF1 ID */ val = readl(d->regs + DSI_CMD_MODE_CTL); /* - * If we enable low-power mode here with - * val |= DSI_CMD_MODE_CTL_IF1_LP_EN + * If we enable low-power mode here * the display updates become really slow. */ + if (d->mdsi->mode_flags & MIPI_DSI_MODE_LPM) + val |= DSI_CMD_MODE_CTL_IF1_LP_EN; val &= ~DSI_CMD_MODE_CTL_IF1_ID_MASK; writel(val, d->regs + DSI_CMD_MODE_CTL); } -- 2.26.2 _______________________________________________ dri-devel mailing list [email protected] https://lists.freedesktop.org/mailman/listinfo/dri-devel
