On 06/20/2013 10:06 PM, Russell King - ARM Linux wrote:
On Thu, Jun 20, 2013 at 09:46:03PM +0200, Sebastian Hesselbarth wrote:
+ ref_pix = 3 + mode->hsync_start - mode->hdisplay;
+ de_pix_s = mode->htotal - mode->hdisplay;
+ de_pix_e = de_pix_s + mode->hdisplay;
+ hs_pix_s = mode->hsync_start - mode->hdisplay;
+ hs_pix_e = hs_pix_s + mode->hsync_end - mode->hsync_start;
Correct, however, these can be simplified.
[...]
These calculations are the same as what was originally in the driver:
+ de_start = mode->htotal - mode->hdisplay;
+ de_end = mode->htotal;
+ hs_start = mode->hsync_start - mode->hdisplay;
+ hs_end = mode->hsync_end - mode->hdisplay;
when it was first committed.
This is otherwise exactly what I came up with which gets my TV working
again in HDMI mode.
Russell,
I am fine with any way to describe de/hs but you should notice that
I also modified refpix/refline and added interlaced sync. With the
original sync calculation, on some modes there was source blanking
captured by TDA998x which was also visible in the output image. I
chose the above description to make it more readable.
Also the patch takes care of input sync and output sync inversion
while the original driver always expected positive HS/VS.
I tested these sync settings on 4 DVI monitors and TV sets all
accepted each mode perfectly. Especially, not-so-cheap TV sets
are very picky about wrong sync.
Sebastian
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
http://lists.freedesktop.org/mailman/listinfo/dri-devel
