On Wed, Sep 03, 2025 at 08:17:33AM +0200, Mike Looijmans wrote: > On 02-09-2025 19:29, Maxime Ripard wrote: > > On Mon, Sep 01, 2025 at 04:29:01PM +0200, Mike Looijmans wrote: > > > + ti,retimer-threshold-hz: > > > + minimum: 25000000 > > > + maximum: 600000000 > > > + default: 200000000 > > > + description: > > > + Cross-over point. Up until this pixel clock frequency > > > + the chip remains in the low-power redriver mode. Above > > > + the threshold the chip should operate in retimer mode. > > Why should anyone want to tune this at the firmware level? > > It's a board property. You'd set this based on the hardware you've soldered > on. If your clock and serdes are good quality, there's no need for the chip > to be in retimer mode (it will consume more power and actually make the > signal worse). At higher speeds, that situation may change, hence the need > for a way to describe that. The chip has a similar function built in, but > with only 2 choices of cross-over point. > > To tune these parameters (retimer, equalizer), you'll probably have to take > your equipment to a test facility (like we did). It's not something that > end-users would want to tune themselves. > > Most of these settings can also be done using pin strapping. I guess it'd be > helpful if I added that to the description. > > > > > + ti,dvi-mode: > > > + type: boolean > > > + description: Makes the DP159 chip operate in DVI mode. > > Ditto. Both describe policy, not hardware. > > I would set this flag if I've soldered on a DVI connector instead of a HDMI > one. I'd consider that hardware.
Do you need to set this if you have DVI monitor attached to the HDMI connector via the passive cable? As for the connector type, you can check it in the .atomic_enable by checking drm_connector::connector_type. -- With best wishes Dmitry
