On Tue, Nov 25, 2025 at 08:55:07PM +0530, Prahlad Valluru wrote: > Required vco rate is set by programming decimal and fraction > from 64 bit calculation. This programmed rate is not exactly > matching the requested rate and corresponding recalc_rate is > having rounding error due to this delta. > > When setting byte_clk and byte_intf_clk from this pll, > set_rate on byte_intf_clk resulting in dividers getting > reprogrammed, which are already set from byte_clk. > Convert this recalc_rate to KHz and back to Hz to round up > this delta in calculation.
Should the same fix be applied to other generations too? > > Signed-off-by: Prahlad Valluru <[email protected]> > --- > drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c > b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c > index 32f06edd21a9..00f20c5a7c73 100644 > --- a/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c > +++ b/drivers/gpu/drm/msm/dsi/phy/dsi_phy_7nm.c > @@ -598,6 +598,12 @@ static unsigned long dsi_pll_7nm_vco_recalc_rate(struct > clk_hw *hw, > pll_freq += div_u64(tmp64, multiplier); > > vco_rate = pll_freq; > + /* > + * Recalculating the rate from dec and frac doesn't end up the rate > + * we originally set. Convert the freq to KHz, round it up and > + * convert it back to Hz. > + */ > + vco_rate = DIV_ROUND_UP_ULL(vco_rate, 1000) * 1000; > pll_7nm->vco_current_rate = vco_rate; > > DBG("DSI PLL%d returning vco rate = %lu, dec = %x, frac = %x", > > --- > base-commit: 63c971af40365ee706c7e24f6a7900d693518f09 > change-id: 20251125-msm-dsi-phy-7nm-clk-rate-26723a3b686c > > Best regards, > -- > Prahlad Valluru <[email protected]> > -- With best wishes Dmitry
