Hi Kory,
On 26/11/2025 19:35, Kory Maincent (TI.com) wrote:
> Use panel-dpi driver instead of the deprecated tilcdc-panel driver in
> preparation for removing the tilcdc-panel driver and binding.
>
> Signed-off-by: Kory Maincent (TI.com) <[email protected]>
> ---
>
> This patch is not tested. It would be nice if someone with one of this
> board could test and validate it.
> ---
> arch/arm/boot/dts/ti/davinci/da850-evm.dts | 26 +++++++++++++-------------
> arch/arm/boot/dts/ti/omap/am335x-guardian.dts | 25 +++++++++----------------
> arch/arm/boot/dts/ti/omap/am335x-pdu001.dts | 21 ++++++++++-----------
> arch/arm/boot/dts/ti/omap/am335x-pepper.dts | 22 +++++++++++-----------
> arch/arm/boot/dts/ti/omap/am335x-sbc-t335.dts | 25 +++++++++++++------------
> arch/arm/boot/dts/ti/omap/am335x-sl50.dts | 25 ++++++++++++-------------
> 6 files changed, 68 insertions(+), 76 deletions(-)
>
Doesn't this, or rather the following patches, break DTB compatibility
with all the above boards?
Tomi
> diff --git a/arch/arm/boot/dts/ti/davinci/da850-evm.dts
> b/arch/arm/boot/dts/ti/davinci/da850-evm.dts
> index 38a191fb04149..79cca1f6205ef 100644
> --- a/arch/arm/boot/dts/ti/davinci/da850-evm.dts
> +++ b/arch/arm/boot/dts/ti/davinci/da850-evm.dts
> @@ -40,7 +40,7 @@ backlight: backlight-pwm {
> };
>
> panel {
> - compatible = "ti,tilcdc,panel";
> + compatible = "panel-dpi";
> pinctrl-names = "default";
> pinctrl-0 = <&lcd_pins>;
> /*
> @@ -50,17 +50,10 @@ panel {
> */
> status = "okay";
> enable-gpios = <&gpio 40 GPIO_ACTIVE_HIGH>; /* lcd_panel_pwr */
> -
> - panel-info {
> - ac-bias = <255>;
> - ac-bias-intrpt = <0>;
> - dma-burst-sz = <16>;
> - bpp = <16>;
> - fdd = <0x80>;
> - sync-edge = <0>;
> - sync-ctrl = <1>;
> - raster-order = <0>;
> - fifo-th = <1>;
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&lcdc_out>;
> + };
> };
>
> display-timings {
> @@ -222,6 +215,13 @@ &rtc0 {
> };
>
> &lcdc {
> + fifo-threshold = <16>;
> +
> + port {
> + lcdc_out: endpoint {
> + remote-endpoint = <&panel_in>;
> + };
> + };
> status = "okay";
> };
>
> @@ -459,7 +459,7 @@ &vpif {
> pinctrl-0 = <&vpif_capture_pins>, <&vpif_display_pins>;
> /*
> * The vpif and the LCD are mutually exclusive.
> - * To enable VPIF, disable the ti,tilcdc,panel then
> + * To enable VPIF, disable the panel-dpi then
> * change the status below to 'okay'
> */
> status = "disabled";
> diff --git a/arch/arm/boot/dts/ti/omap/am335x-guardian.dts
> b/arch/arm/boot/dts/ti/omap/am335x-guardian.dts
> index 4b070e634b281..f38ce9be2c106 100644
> --- a/arch/arm/boot/dts/ti/omap/am335x-guardian.dts
> +++ b/arch/arm/boot/dts/ti/omap/am335x-guardian.dts
> @@ -68,10 +68,15 @@ gpio-poweroff {
> };
>
> panel {
> - compatible = "ti,tilcdc,panel";
> + compatible = "panel-dpi";
> pinctrl-names = "default", "sleep";
> pinctrl-0 = <&lcd_pins_default &lcd_disen_pins>;
> pinctrl-1 = <&lcd_pins_sleep>;
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&lcdc_out>;
> + };
> + };
>
> display-timings {
> timing-320x240 {
> @@ -86,21 +91,9 @@ timing-320x240 {
> clock-frequency = <9000000>;
> hsync-active = <0>;
> vsync-active = <0>;
> + pixelclk-active = <1>;
> };
> };
> - panel-info {
> - ac-bias = <255>;
> - ac-bias-intrpt = <0>;
> - dma-burst-sz = <16>;
> - bpp = <24>;
> - bus-width = <16>;
> - fdd = <0x80>;
> - sync-edge = <0>;
> - sync-ctrl = <1>;
> - raster-order = <0>;
> - fifo-th = <0>;
> - };
> -
> };
>
> guardian_beeper: pwm-7 {
> @@ -265,8 +258,8 @@ &lcdc {
> blue-and-red-wiring = "crossed";
> status = "okay";
> port {
> - lcdc_0: endpoint@0 {
> - remote-endpoint = <0>;
> + lcdc_out: endpoint@0 {
> + remote-endpoint = <&panel_in>;
> };
> };
> };
> diff --git a/arch/arm/boot/dts/ti/omap/am335x-pdu001.dts
> b/arch/arm/boot/dts/ti/omap/am335x-pdu001.dts
> index c9ccb9de21ad7..2c5229d05ade7 100644
> --- a/arch/arm/boot/dts/ti/omap/am335x-pdu001.dts
> +++ b/arch/arm/boot/dts/ti/omap/am335x-pdu001.dts
> @@ -50,20 +50,14 @@ lis3_reg: fixedregulator@1 {
> };
>
> panel {
> - compatible = "ti,tilcdc,panel";
> + compatible = "panel-dpi";
> status = "okay";
> pinctrl-names = "default";
> pinctrl-0 = <&lcd_pins_s0>;
> - panel-info {
> - ac-bias = <255>;
> - ac-bias-intrpt = <0>;
> - dma-burst-sz = <16>;
> - bpp = <16>;
> - fdd = <0x80>;
> - sync-edge = <0>;
> - sync-ctrl = <1>;
> - raster-order = <0>;
> - fifo-th = <0>;
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&lcdc_out>;
> + };
> };
>
> display-timings {
> @@ -395,6 +389,11 @@ &rtc {
>
> &lcdc {
> status = "okay";
> + port {
> + lcdc_out: endpoint {
> + remote-endpoint = <&panel_in>;
> + };
> + };
> };
>
> &elm {
> diff --git a/arch/arm/boot/dts/ti/omap/am335x-pepper.dts
> b/arch/arm/boot/dts/ti/omap/am335x-pepper.dts
> index e7d561a527fdd..2760c0eab50c2 100644
> --- a/arch/arm/boot/dts/ti/omap/am335x-pepper.dts
> +++ b/arch/arm/boot/dts/ti/omap/am335x-pepper.dts
> @@ -31,7 +31,7 @@ leds: user-leds-pins {
> };
>
> panel: lcd_panel {
> - compatible = "ti,tilcdc,panel";
> + compatible = "panel-dpi";
> };
>
> sound: sound_iface {
> @@ -189,16 +189,10 @@ &panel {
> status = "okay";
> pinctrl-names = "default";
> pinctrl-0 = <&lcd_pins>;
> - panel-info {
> - ac-bias = <255>;
> - ac-bias-intrpt = <0>;
> - dma-burst-sz = <16>;
> - bpp = <32>;
> - fdd = <0x80>;
> - sync-edge = <0>;
> - sync-ctrl = <1>;
> - raster-order = <0>;
> - fifo-th = <0>;
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&lcdc_out>;
> + };
> };
> display-timings {
> native-mode = <&timing0>;
> @@ -214,12 +208,18 @@ timing0: timing-480x272 {
> vsync-len = <10>;
> hsync-active = <1>;
> vsync-active = <1>;
> + pixelclk-active = <1>;
> };
> };
> };
>
> &lcdc {
> status = "okay";
> + port {
> + lcdc_out: endpoint {
> + remote-endpoint = <&panel_in>;
> + };
> + };
> };
>
> &am33xx_pinmux {
> diff --git a/arch/arm/boot/dts/ti/omap/am335x-sbc-t335.dts
> b/arch/arm/boot/dts/ti/omap/am335x-sbc-t335.dts
> index 2841e95d9a094..25ee855dd21a7 100644
> --- a/arch/arm/boot/dts/ti/omap/am335x-sbc-t335.dts
> +++ b/arch/arm/boot/dts/ti/omap/am335x-sbc-t335.dts
> @@ -13,23 +13,17 @@ / {
>
> /* DRM display driver */
> panel {
> - compatible = "ti,tilcdc,panel";
> + compatible = "panel-dpi";
> status = "okay";
> pinctrl-names = "default", "sleep";
> pinctrl-0 = <&lcd_pins_default>;
> pinctrl-1 = <&lcd_pins_sleep>;
> -
> - panel-info {
> - ac-bias = <255>;
> - ac-bias-intrpt = <0>;
> - dma-burst-sz = <16>;
> - bpp = <32>;
> - fdd = <0x80>;
> - sync-edge = <0>;
> - sync-ctrl = <1>;
> - raster-order = <0>;
> - fifo-th = <0>;
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&lcdc_out>;
> + };
> };
> +
> display-timings {
> /* Timing selection performed by U-Boot */
> timing0: lcd {/* 800x480p62 */
> @@ -44,6 +38,7 @@ timing0: lcd {/* 800x480p62 */
> vsync-len = <2>;
> hsync-active = <1>;
> vsync-active = <1>;
> + pixelclk-active = <1>;
> };
> timing1: dvi { /* 1024x768p60 */
> clock-frequency = <65000000>;
> @@ -57,6 +52,7 @@ timing1: dvi { /* 1024x768p60 */
> vsync-len = <6>;
> hsync-active = <0>;
> vsync-active = <0>;
> + pixelclk-active = <1>;
> };
> };
> };
> @@ -173,4 +169,9 @@ lcd-ena-hog {
> /* Display */
> &lcdc {
> status = "okay";
> + port {
> + lcdc_out: endpoint {
> + remote-endpoint = <&panel_in>;
> + };
> + };
> };
> diff --git a/arch/arm/boot/dts/ti/omap/am335x-sl50.dts
> b/arch/arm/boot/dts/ti/omap/am335x-sl50.dts
> index f3524e5ee43e2..b4b2b6d18d646 100644
> --- a/arch/arm/boot/dts/ti/omap/am335x-sl50.dts
> +++ b/arch/arm/boot/dts/ti/omap/am335x-sl50.dts
> @@ -123,22 +123,14 @@ audio_mclk: audio_mclk_gate@0 {
> };
>
> panel: lcd_panel {
> - compatible = "ti,tilcdc,panel";
> + compatible = "panel-dpi";
> pinctrl-names = "default";
> pinctrl-0 = <&lcd_pins>;
>
> - panel-info {
> - ac-bias = <255>;
> - ac-bias-intrpt = <0>;
> - dma-burst-sz = <16>;
> - bpp = <16>;
> - fdd = <0x80>;
> - tft-alt-mode = <0>;
> - mono-8bit-mode = <0>;
> - sync-edge = <0>;
> - sync-ctrl = <1>;
> - raster-order = <0>;
> - fifo-th = <0>;
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&lcdc_out>;
> + };
> };
>
> display-timings {
> @@ -157,6 +149,8 @@ timing0: 960x128 {
> vfront-porch = <8>;
> vsync-len = <4>;
> vsync-active = <0>;
> +
> + pixelclk-active = <1>;
> };
> };
> };
> @@ -711,6 +705,11 @@ &ehrpwm1 {
>
> &lcdc {
> status = "okay";
> + port {
> + lcdc_out: endpoint {
> + remote-endpoint = <&panel_in>;
> + };
> + };
> };
>
> &tscadc {
>
