On 3/13/2026 6:06 PM, Ville Syrjälä wrote:
On Wed, Mar 11, 2026 at 05:06:05PM +0530, Ankit Nautiyal wrote:
AS SDP may be transmitted at T1 or T2 depending on Panel Replay and
Adaptive Sync SDP configuration as per DP 2.1. Current we are using
T1 only, but future PR/AS SDP modes/features may require T2 or dynamic
selection.
Introduce a helper to return the appropriate AS SDP transmission time so
that a single value is consistently used for programming PR_ALPM.
For now this returns T1.
v2: Avoid adding new member to crtc_state; use a helper. (Ville)
Signed-off-by: Ankit Nautiyal <[email protected]>
---
drivers/gpu/drm/i915/display/intel_alpm.c | 20 +++++++++++++++++++-
drivers/gpu/drm/i915/display/intel_dp.c | 9 +++++++++
drivers/gpu/drm/i915/display/intel_dp.h | 2 ++
3 files changed, 30 insertions(+), 1 deletion(-)
diff --git a/drivers/gpu/drm/i915/display/intel_alpm.c
b/drivers/gpu/drm/i915/display/intel_alpm.c
index a7350ce8e716..0a6da3f926d3 100644
--- a/drivers/gpu/drm/i915/display/intel_alpm.c
+++ b/drivers/gpu/drm/i915/display/intel_alpm.c
@@ -11,6 +11,7 @@
#include "intel_crtc.h"
#include "intel_de.h"
#include "intel_display_types.h"
+#include "intel_display_utils.h"
#include "intel_dp.h"
#include "intel_dp_aux.h"
#include "intel_psr.h"
@@ -359,6 +360,23 @@ void intel_alpm_lobf_compute_config(struct intel_dp
*intel_dp,
crtc_state->has_lobf = true;
}
+static int get_pr_alpm_as_sdp_transmission_time(const struct intel_crtc_state *crtc_state)
The type should be u32 since it returns a (partial) register value.
+{
+ int as_sdp_setup_time = intel_dp_as_sdp_transmission_time();
+
+ switch (as_sdp_setup_time) {
+ case DP_PR_AS_SDP_SETUP_TIME_T1:
+ return PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_T1;
+ case DP_PR_AS_SDP_SETUP_TIME_DYNAMIC:
+ return PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_T1_OR_T2;
+ case DP_PR_AS_SDP_SETUP_TIME_T2:
+ return PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_T2;
+ default:
+ MISSING_CASE(as_sdp_setup_time);
+ return PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_T1;
+ }
+}
+
static void lnl_alpm_configure(struct intel_dp *intel_dp,
const struct intel_crtc_state *crtc_state)
{
@@ -382,7 +400,7 @@ static void lnl_alpm_configure(struct intel_dp *intel_dp,
ALPM_CTL_AUX_LESS_WAKE_TIME(crtc_state->alpm_state.aux_less_wake_lines);
if (intel_dp->as_sdp_supported) {
- u32 pr_alpm_ctl =
PR_ALPM_CTL_ADAPTIVE_SYNC_SDP_POSITION_T1;
+ u32 pr_alpm_ctl =
get_pr_alpm_as_sdp_transmission_time(crtc_state);
if (crtc_state->link_off_after_as_sdp_when_pr_active)
pr_alpm_ctl |=
PR_ALPM_CTL_ALLOW_LINK_OFF_BETWEEN_AS_SDP_AND_SU;
diff --git a/drivers/gpu/drm/i915/display/intel_dp.c
b/drivers/gpu/drm/i915/display/intel_dp.c
index e6148e7f0ebc..74a8af3cf18c 100644
--- a/drivers/gpu/drm/i915/display/intel_dp.c
+++ b/drivers/gpu/drm/i915/display/intel_dp.c
@@ -7439,3 +7439,12 @@ bool intel_dp_joiner_candidate_valid(struct
intel_connector *connector,
return true;
}
+
+int intel_dp_as_sdp_transmission_time(void)
+{
+ /*
+ * For now we use T1 as the transmission time.
+ * This can be later changed as per requirements.
+ */
IIRC Bspec actually says we must use T1.
I am a bit confused. As per spec 68920:
"When Panel Replay is inactive (this includes entry and exit frames),
then the Source will always send the AS SDP on T1.
When Panel Replay is active, then the position of the packet may change
depending on the V. Total mode and whether the target refresh rate (TRR)
has been reached or not.
As per the table, T2 is needed for Fixed Vtotal mode and a case of Fixed
average Vtotal (TRR reached)."
However the above is coming from the DP spec.
Later the spec mentions :
The position of the AS SDPs must be kept at T1 if Software plans on
doing refresh rate changes while DC6v is enabled
PR_ALPM_CTL[ Adaptive Sync SDP Position ] = 01b (T1 Always)
DPCD 0011Ah[7:6] = 00b
So I guess we can just go with T1 for now?
Regards,
Ankit
+ return DP_PR_AS_SDP_SETUP_TIME_T1;
+}
diff --git a/drivers/gpu/drm/i915/display/intel_dp.h
b/drivers/gpu/drm/i915/display/intel_dp.h
index 2849b9ecdc71..2e4609d9d05c 100644
--- a/drivers/gpu/drm/i915/display/intel_dp.h
+++ b/drivers/gpu/drm/i915/display/intel_dp.h
@@ -238,4 +238,6 @@ bool intel_dp_joiner_candidate_valid(struct intel_connector
*connector,
for ((__num_joined_pipes) = 1; (__num_joined_pipes) <=
(I915_MAX_PIPES); (__num_joined_pipes)++) \
for_each_if(intel_dp_joiner_candidate_valid(__connector,
(__mode)->hdisplay, __num_joined_pipes))
+int intel_dp_as_sdp_transmission_time(void);
+
#endif /* __INTEL_DP_H__ */
--
2.45.2
