Hi, On Wed, Jul 15, 2026 at 03:25:11PM +0200, AngeloGioacchino Del Regno wrote: > On 7/15/26 14:53, Esben Haabendal wrote: > > Gary Bisson <[email protected]> writes: > > > > > Some bridges, such as the TI SN65DSI83, require the HS clock to be > > > running in order to lock its PLL during its own pre-enable function. > > > > > > Without this change, the bridge gives the following error: > > > sn65dsi83 14-002c: failed to lock PLL, ret=-110 > > > sn65dsi83 14-002c: Unexpected link status 0x01 > > > sn65dsi83 14-002c: reset the pipe > > > > > > Move the necessary functions from enable to pre-enable. > > > > > > Signed-off-by: Gary Bisson <[email protected]> > > > > Hi > > > > I have run into the same problem, but in combination with another > > pipeline. I am seeing same problem with an i.MX8 using the nwl-dsi > > bridge and the dcss driver. > > > > I have submitted a fix that adresses the problem in the ti-sn65dsi83 > > driver instead. With a bit of luck, it can replace the fix proposed in > > this thread. > > > > See > > https://lore.kernel.org/all/[email protected]/
Thanks, just tried it on 7.2-rc3 with my patch reverted and confirm that it works too. My assumption was that the SN65DSI83 was locking the PLL earlier for some specific reason and therefore was reluctant to change it. > > /Esben > > That clarifies a lot of things. > > The patch on mtk_dsi shall be reverted then. Angelo, do you want me to offer the revert patch? Should I wait to see how the other thread goes? Regards, Gary
